Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION OF DIFFERENT PARTS
Starting up the laminating machine
Hot laminating ('Hot')
1. Push the plug into the mains socket outlet and set the switch to 'Hot'. The red
LED (Power) lights up and the heating process will begin.
2. The green LED (Ready) lights up after approximately 3 minutes (operational
indicator lamp for the hot laminating). Now you can begin the laminating
process.
3. Open the laminating film and lay the material that is to be laminated directly
onto the closed side. Leave a margin of between 3 mm and 5 mm
approximately beyond the edges while doing so.
Caution
a) Choose a film of correspondingly suitable size in relation to the material that is to
be laminated respectively.
b) It is not recommended to process several smaller materials in one film.
c) Do not cut up the film before the laminating is done.
d) The material that is to be laminated, is not allowed to be thicker than 0.5 mm
including the film.
e) It is imperative to only laminate very thin or soft materials, like newspaper or
serviettes for example, with thicker films (125 microns). We recommend refraining
from any attempt to do so!
f) Do not insert any laminating film without the contents.
g) Never utilize laminating pockets on one side or when they are rolled up.
h) Only utilize laminating foils that are also described as such. Other kinds of film, like
transparent wallets for example, are unsuitable for laminating!
i) When the product is in condition of "Hot" lamination, Blue light means it is ready to
use (Red light means it is not ready and being activated)
A.
Pouch entrance
B.
Switch 80-100/ Off / 125mic
C.
Pouch exit
D.
ABS: Anti-Block-System/ jam
release
7
Publicidad
