Publicidad
Idiomas disponibles
Idiomas disponibles
Before Using the Telescopic Pruning Saw:
a. Remove the battery pack.
b. Confirm that the kickback guard is undamaged and functioning properly.
c. Make sure that the chain is properly mounted and correctly tensioned: Lift the tip of the
guide bar up to check for any sagging in the saw chain. The saw chain is correctly tensioned
when there is no sag on the underside of the guide bar and the saw chain is snug, but it can
be turned by hand without binding. If the tension requires adjustment, refer to the chapter
"Adjusting the Chain Tension" in the "Maintenance" section of this manual for instructions.
d. Check the tightness of the side-cover knob before use. If it is loose, securely tighten the
side-cover knob by turning it clockwise.
e. Check the sharpness of the cutting teeth of the saw chain.
f. Make sure the saw chain is well lubricated.
g. Stand upright and hold the pruning saw in a relaxed position.
h. Make sure the saw chain is not touching the ground or any other objects.
i. Hold the saw firmly – refer to chapter "Proper Grip on Handles" below.
j. Make sure that you have a secure and balanced footing. Watch out for obstacles such as
tree stumps, roots, and ditches, which could cause you to trip or stumble.
k. Always make a trial cut in scrap material before making an accurate cut.
Preparation for Cutting
Refer to safety instructions earlier in this manual for appropriate safety equipment.
Work Area Precautions
Cut only wood or materials made from wood. Do not cut sheet metal, plastics, masonry, or
•
non-wood building materials.
Never allow children to operate the pruning saw.
•
Allow no person, who has not read this Owner's Manual or received adequate instructions for
•
the safe and proper use of this saw, to use this saw.
During bucking operations, keep a minimum distance of 15 feet (4.5 m) between workers.
•
Tree branches should not be trimmed in a manner that would endanger any person, strike
any utility line, or cause any property damage. If a branch does make contact with any utility
line, stay clear of the tree and the line and notify the utility company immediately.
Always operate the saw with both feet on solid ground to prevent being pulled off balance.
•
Do not cut above chest height, as a saw held higher is difficult to control against kickback
•
forces.
Do not prune trees near electrical wires or buildings.
•
Cut only when visibility and light are adequate for you to see clearly.
•
20
Publicidad
