Publicidad
Idiomas disponibles
Idiomas disponibles
8-Ring Maintenance
Purchasean O-Ring Repair Kit at your Iocai Searsor by caliing
1-800-4-MY-HOME(469-4663) or oniine at www.sears.com,it
is not includedwith the pressurewasher.This kit includes
replacement o -rings, rubberwasher and water inlet fiiter. Referto
tile instruction sheetprovidedin the kit to serviceyour unit's
o-rings.
WARNING
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underiying tissues, ieading to serious injury and
)ossible amputation.
• NEVER repairleakingconnections with sealant o f anykind.
Replace o-ringor seal.
Pump Oil Maintenance
DONOTattempt any oil maintenanceon this pump. This
model does not require any pump oii maintenance. The pump
is pre-iubricated and sealed from the factory, requiring no
additional lubrication for the life of the pump.
ENGINEMAINTENANCE
WARNING
-_
Unintentional sparking can result in fire or
_¢
electric shock.
WHENA#JUSTING8R _IAKINGI_EPAIRS T8 YGUR
PI_ESSURE W ASNER
* Disconnect the spark plugwire from the sparkplugand place
the wire whereit cannotcontactsparkplug.
WNENTESTING FGRENGINE SPARK
* Useapproved sparkplug tester
, DONOTcheck for sparkwith sparkplug removed.
Oil
GimI_ecemmendatiens
We recommend the use of Briggs & Stratton Warranty
Certified oiis for best performance. Other higil=quality deter=
gent oiis are acceptabie if classified for service SF, SG, SH,
SJ or higher=DO NOT use speciai additives=
Outdoor temperatures determine the proper oii viscosity for
the engine=Use the chart to setect the best viscosity for the
outdoor temperature range expected.
oF
104 _
*
__
,
86
_u_
68 --w
_
32
14
-4
-22
°C
2O
;I--lo
_'_
_0
* Below40% (4°C)the useof SAE30 will result in hard starting.
** Above80°F(27°C)the useof 10W30maycauseincreased oil
consurnption. C heckoil levelmorefrequently.
NOTE:Synthetic oiI meeting iLSAC GF-2, APi certifi-
! cation mark and API service symbol with "SJ/CF
ENERGYCONSERVING" o r Ngher, is an acceptable
oil at ali temperatures. Use of synthetic oil does not
alter required oil change intervals.
Checking8ii Level
OiI level should be checked prior to each use or at least every
5 hours of operation. Keep oil ievei maintained=
1.
Make sure pressure washer is on a ievei surface.
2.
Remove oii dipstick and wipe dipstick with ctean cioth.
Reptaceand tigilten dipstick. Removeand and check oil
level.
3.
Verify oii is at "Fulr' mark on dipstick. Replace and
tigllten dipstick.
18
Publicidad
