Publicidad
Idiomas disponibles
Idiomas disponibles
LINE REPLACEMENT
Pre-wound
spools offer the most con-
venient method for replacing line and
ensuring optimum performance.
* Replacement spools are celor-coded
to ensure use of the correct spool with
your unit.
Be sure to use the same
color spool as the existing spool.
NOTE:
Always clear dirt and debris
from cutting head components
when
performing any type of maintenance,
* Hold spool and unscrew cap by turning
in the direction shown on top of the cap.
* Remove line guide ring and spool.
Line guide ring
Cap
X
Use a pre-wound
spool or refill spool
with line. If using a pre-wound
spool,
remove tape strip from line and spool.
REFILLING THE SPOOL WITH LINE
i_ WARNING:
Use only 0.080
inch (2 mm) diameter round line.
Other sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
1. Cut a length of 25 feet of 0.080 inch
(2 mm) diameter round Craftsman
brand line.
,n
Spool.
__
Spool
2. Insert one end of line into center
cavity of empty spool. Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3. Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound from center of spool.
INSTALLING
SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring
1
s
Replacement Spool
3. Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm) from
center of spool.
4. Ensure line remains in slot while
screwing cap on to the shaft. Only
tighten cap hand tight!
CARBURETOR
ADJUSTMENT
_WARNING:
Keep others away
when making idle speed adjustments.
The trimmer head will be spinning dur-
ing this procedure.
Wear your protec-
tive equipment and observe all safety
precautions.
The carburetor
has been carefully set
at the factory. Adjustments
may be
necessary if you notice any of the fol-
lowing conditions:
• Engine will not idle when the throttle is
released.
Make adjustments with the unit sup-
ported so the cutting attachment
is off
the ground and will not make contact
with any object.
Hold the unit by hand
while running and making adjust-
ments. Keep all parts of your body
away from the cutting attachment
and
muffler.
Idle Speed Adjustment
Allow engine to idle, Adjust speed until
engine runs without stalling (idle
speed too slow).
Turn idle speed screw clockwise to
increase engine speed if engine
stalls or dies.
• Turn idle speed screw counterclock-
wise to decrease engine speed.
10
Publicidad
