Descargar Imprimir esta página

Krüger & Matz KM0232-S6 Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16
Caution
Do not place your television on an
unstable cart, stand, shelf or table.
Serious injury to an individual , and
damage to the television, may result
if it should fall.
INSTALLATION
• Locate the TV in the room where light does not strike the screen directly.
• TotaI darkness or a reflection on the picture screen can cause eyestrain. Soft
and indirect lighting is recommended for comfortable viewing.
• AIIow enough space between the TV and the wall to permit ventilation.
• Avoid excessively warm locations to prevent possible damage to the cabinet
or premature component failure.
• Do not cover the ventilation openings when using the TV.
Minimum distances
Base stand assembly instruction
When you install the base, the need to face down flat on the TV platform.
Before installing (or removing) the stand, unplug the AC power cord from the
AC outlet before performing the operation, laying cushion in place the TV will
be placed to prevent damage to the TV.
24
Owner's manual
Caution
When the television receiver is not
used for an extended period of time,
it is advisable to disconnect the AC
power cord from the AC outlet.
Owner's manual
A
B
Warning:
Be sure to follow the instructions for installation, if the base is not installed
correctly, it may result in the TV falling over. To remove the stand, perform the
steps in reverse order, the base can not adjust the angle. During the installation
process, be careful to avoid damage to the TV and your hand caught and ground
to the bottom of the TV.
Mounting on a wall
IMPORTANT This operation requires two people!
To ensure a safe installation, comply with the following safety instructions:
• Disconnect from power supply before mounting.
• Check that the wall can support the weight of the TV set and wall mount assembly.
• Follow the mounting instructions provided with the wall mount.
• The TV set must be installed on a vertical wall.
• Make sure to use only screws suitable for the material of the wall.
• Make sure that the TV set cables are placed in such a way that there is no
danger of tripping over them.
• Mounting the TV set on the wall should be performed only by professionals.
Step 1
Locate the 2 pcs of bottom
bracket into the gap in the
bottom of the TV, and check
that it is securely held in place
as in illustration A) below.
Step 2
Lock the 2 pcs screws in the
designated
location
as
in
illustration B) below. Check
each screw is firmly tightened.
25

Publicidad

loading