Use And Maintenance - MARESKA B1WL01 Manual De Instrucciones

EN
I) If there is need to cut excess fabric from the panel, be careful
to cut the right segment.
J) OPTIONAL: In order to avoid fraying of superior and inferior
edges, a small welding device or lighter may be used to weld
wires.
8. Installing the lock hooks
When all the holes are drilled and all the panels installed, they
need to be connected to each another using the lock hooks in-
cluded in the package. To install the hooks, follow these steps:
• Release the superior screw of the poles with the help of a
screwdriver and a bit holder (see figure 1).
• With the hook, screw carabiners to the poles (see figures 2
and 3).
• To close the hook, follow these steps (see figure 4).
1. Hold the two poles and put pressure on them to bring
them closer together
2. Release the safety latch (the movable piece on one
end of the spring)
3. Lower the hook and let go of it

USE AND MAINTENANCE

9. Access to the pool
It is possible to access the pool through each of the panel con-
nections, by unblocking the safety hooks. Follow these steps
for disconnecting (see figure 5):
• Hold the two poles and put pressure on them to bring them
closer together.
• Release the safety latch on the hook (the movable piece on
one end of the spring).
• Lift up the hook to release the connection between the panels.
• Lift up the pole by turning it.
WARNING:
THE POLE CANNOT BE REMOVED IF YOU SIMPLY PULL WITHOUT TURNING IT AT THE
SAME TIME. IT IS IMPERATIVE THAT ACCESS POINTS ARE CLOSED AT THE END OF THE SEASON
OF SUPERVISED SWIMMING.
16
I
Figure 1
Figure 3
1 1
Figure 5
J
Figure 2
Figure 4
3