A_out
TurboCooL
TM
(on some models)
GEApWiances.com
(on some models)
, iilq i ilil
ii
T M
iii( ! j
_!!_ i iii._ ._ 4_!i_j_i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiii_!ii
_ ii_i_ij_iji
TM
(on some models
How It Works
TurboCool rapidly cools the refrigerator
compartment in order to more quickly
cool foods. Use TurboCool when adding a
large amount of food to the refrigerator
compartment, putting away foods after they
have been sitting out at room temperature or
when putting away warm leftovers. It can
also be used if the refrigerator has been
without power for an extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and
off at high speed as needed for eight hours.
The compressor will continue to run until the
refrigerator compartment cools to
approximately 3/4°F(1°C),then it will cycle on
end off to maintain this setting. After 8 hours,
or if TurboCool is pressed again, the
refrigerator compartment will return to
the original setting.
How to Use
PressTurboCooL The refrigerator
temperature display will showbc.
After TurboCool is complete, the
refrigerator compartment will return
to the original setting.
NOTES: The refrigerator temperature cannot
be changed during TurSoCool.
The freezer temperature is not
affected during TurboCool.
When opening the refrigerator door
during TurSoCool,the fans
will continue to run if they have
cycled on.
(on some models)
iii!i_ii_J
>_ ii
_ _ q_ii_i_i_i_/ii_!i
i/_//
DOOR
ALARM
(on some models)
About
Door
Alarm
(onsome models)
The door alarm will sound if any door is open
for more than 2 minutes. The beeping stops
when you close the door.
!
i iii
(on some models)
z
L
IL
.
m
ENERGY
SAVER
(on some models)
About Energy Saver Ion
some models)
This product is equipped with an Energy
Saver feature. The refrigerator is shipped with
the Energy Saverfeature enabled.
Over time, moisture can form on the front
surface of the refrigerator cabinet and cause
rust. If moisture does appear on the front
surface of the refrigerator cabinet, turn off
the Energy Saverfeature by pressing and
releasing the ENERGY'SAVER p ad on the
control panel.