cecotec VISIONTOAST Manual De Instrucciones página 57

4. TROUBLESHOOTING
Problem
The toaster does not work.
Bread stuck in the slot.
Bread slices cannot be seen over the slot after
toasting.
The toast is too dark or too light.
The toaster emits smoke.
- If you experience problems with your toaster, check the issues below to make sure it
has been properly assembled before returning the appliance to your dealer or getting in
contact with the official Technical Support Service of Cecotec.
- Make sure the toaster is safely plugged in.
- If you have recently cleaned the glass panel, make sure the panel is properly installed.
- To remove the glass panel, hold the toaster with one hand and lightly tilt it backwards.
Press the latch at the bottom, pull out the glass gently and clean it (Fig. 4).
- To reinsert the glass panel, lay the toaster on one side, hold the panel by the latch and
carefully slide it back in place until it clicks into place.
Solution
Check the power connection and make sure the
plug it properly connected to the wall outlet. If
it does not work, contact the official Technical
Support Service of Cecotec.
Unplug the toaster and let it cool down. Then,
carefully remove the slice or slices from the
toaster. You may need to hold the toaster over
a sink and shake it gently to help loosen the
bread. Do not use metal objects to remove the
bread. Do not touch the metal parts inside the
toaster.
If the bread slices are too small to be removed
from the toaster, unplug the toaster and use
thin, heat-resistant tongs to remove the bread
from the toasting slot.
The selected intensity level is too high or too
low. Adjust it.
The selected intensity level is too high for that
type of bread. Press STOP/START to stop the
toasting process. Make sure the crumb tray
is empty and clean. Turn the unplugged unit
upside down over the sink and shake it gently.
ENGLISH
VISIONTOAST
57