Publicidad
Idiomas disponibles
Idiomas disponibles
SETTINGS
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with [OH A/T] and the TV
memorizes them even if you switch wires.
NOTE:
]
° Make sure if the TV is connected
to antenna or cable,
1 Display the setup screen.
. Press [SETUP].
The following setup screen is displayed.
3 For TV channels, using [A/'V], select "Air".
For CATV channels, select "Cable".
• Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
• When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
broadcasting will be displayed.
NOTES:
° ff you connect
cable system
directly,
contact
the
CATV installer.
°ff you press
[POWER]
or [SETUP]
during
Autoscan,
this
setting will be canceled.
° tf there is no reception
connected
or poor signal is detected.
a Hint will appear on screen once scanning stops,
09
(5
UJ
09
..J
uJ
z
z
=t=
o
t_
(5
z
E
m
.-1
E
2
Select "CHANNEL" and press [ENTER] to con-
firm.
• Using [A/T],
select "Autoscan".
. Press [ENTER].
EN
Publicidad
