Hoover SteamVac Manual Del Propietário página 5

CARTONCONTENTS
A. Upper Handle
B. Midsection
C. Base
D. Upholstery/Stair Hose Adapter
E. Tool Caddy
F. Upholstery/Stair Hose
G. Upholstery/Stair Attachment
H. (1) Upper Handle screw
I. (2) Right and Left Base Screws
J. (1) Middle Base Screw
K. (3) Nuts
Remove all parts from carton and identify each
item shown.
Make sure all parts are located before disposing of
packing materials.
NOTE: Phillips screwdriver needed for assembly
A
_li __ I
©©©
C
K
B
BODYAND HANDLEASSEMBLY
1.2 Stand base in upright position. Push midsection
onto base by aligning tabs on the backside of
midsection and the pockets on the backside of
base. Assemble the two (2) lower handle screws
in the following manner: while holding nut in place,
insert screw through front of midsection and tighten.
• IMPORTANT •
Make sure the power cord is out of the way to
avoid pinching.
1,3 Slide upper handle down onto unit, Place screw
into recess in back of upper handle and tighten.