Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
English
After assembly, the space between the top and bo-
A
ttom of the worktop is indicated in figure 5 with "A".
This is for ventilation and must not be covered.
Installation requirements
The dimensions of the product are shown in figure 3.
Figura 5
The surface of the cabinet and of the mounting ma-
terial must have a minimum temperature resistance
of 100°C.
The installation cabinet must be fixed.
The surface must be flat to prevent the product from
tilting.
The base of the cabinet must be strong enough to
withstand a load of 60 kg.
Positioning and fixing the oven
Place the oven in the cabinet with the help of two or
more people.
Make sure that the oven frame and the front edge of
the cabinet are evenly matched.
The power cable must not be under the oven, pinched
between the oven and the cabinet or bent.
Secure the oven to the cabinet using the screws supplied with the product.
The screws should be positioned as shown in figure 5, passing them through the plastics attached to the
frame of the product. Do not overtighten the screws. Otherwise, the screw cavities may wear out.
Check that the oven does not move after assembly. If the furnace is not assembled according to the
instructions, there is a risk of the furnace tilting during operation.
Electrical connection
The place of installation of the product must have a suitable electrical installation.
The mains voltage must be compatible with the values indicated on the rating plate of the product.
The product must be connected in accordance with local and national electrical regulations.
Before starting the installation, disconnect the power supply.
Do not connect the product to the mains until the installation has been completed.
39
infiniton.es
Publicidad
