Kingfisher NY2009-20MR Manual Del Usuario página 37

08 Shut down
Under the working state, press the power key "
the power cord, wait for the whole appliance to cool, and place the heater in a stable and safe position.
NOTE:
To use the appliance for the first time or to re-insert the socket, pay attention to check whether the plug and
the socket are fitted well.
09 Inspection method
Insert the power plug into the socket and start using; after about half an hour, turn off and pull out the plug.
Check whether the plug pins are hot; replace the socket if so (more than about 50 °C) to avoid burning the
plug or even causing a fire caused by overheating of the socket due to poor contact.
10 Cable reel instruction
Control panel
NOTE: This heater is fitted with a non-adjustable internal thermostat that regulates the heaters operating
temperature and prevents overheating. Therefore it is normal for the heater to automatically switch on and
off during normal use. The non-adjustable internal thermostat works independently and does not affect the
thermostat setting on the control panel.
Safety Control (Tip over switch): This product is fitted with a safety tip-over switch to ensure it can only
be operated in the correct upright position. If the unit tips over, please recover it to the upright position to
operate correctly.
5059340471648_MNL_IN_V06.indb 36 5059340471648_MNL_IN_V06.indb 36
Display window
Press here
" on the control panel to enter the standby state. Unplug
These two
will pop up
36
Wind up
the power
cord.
27/6/2022 11:19 AM 27/6/2022 11:19 AM