Trust PREMIUM-LINE ZCO-900 Manual Del Usuario página 7

1. REMOVE BATTERY PULL STRIP
A
Remove the detector from the mounting bracket by twisting it.
B
Pull the battery pull strip out of the CO detector. After removing the battery pull strip, the CO detector will beep and will
warm up (can take up to 2 min). (See LED function table)
2. INDICATORS
The CO detector contains an LED indicator light to indicate the status. Look below for the meaning of the different LED
indications.
LED FUNCTION TABLE
Warming up LED light flashes red, green and yellow
Connected LED will light up for 3 sec (The App will also indicate when
successfully the connection is successful)
Detector reset LED will flash 6x
Test LED light flashes 4x fast red and the detector beeps 4x
Alarm LED light flashes red and the detector beeps 4x (85 db)
every 5 seconds. The detector stops as soon as no more
CO is detected
Operation of The LED light flashes 1x green every 30 seconds to
CO detector indicate that the CO alarm is working properly
Battery low LED light flashes 1x yellow and the detector beeps every
indication 30 seconds
Error LED light flashes 2x yellow and the detector beeps 1x long
and 1x short every 30 seconds. Remove the battery and
insert it again.
Replace LED light flashes 2x yellow and gives 1 long and 1 short
beep every 30 seconds. The detector needs to be
detector
replaced
ZCO-900 CARBON MONOXIDE DETECTOR
EN
7