Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions before riding
Dear users, for your safety and to prevent safety accidents, please do the following checks before riding. If there
is any abnormality，please repair it in time or find a professional repair!
(1)Inspection of power supply circuit and lighting circuit:
Check whether the power supply circuit, lighting circuit and device are damaged; Turn on the power supply,
operate the lighting switch, check whether the headlights and taillights are on, and whether the brightness of the
headlights and taillights is normal;
Check that the right brake handle is corresponding to the rear brake, while the left brake handle is correspond-
ing to the front brake, and the brake icon is indicated on the display.
(2)Check of brake device:
Check whether the front and rear brakes can work normally; Check the braking effect of the front and rear
brakes to ensure that the brakes are normal and effective;
Confirm whether the power-off switch is normal when the rear wheels are off the ground with the support of
the whole vehicle;
Please check the fastening status of each axle to ensure that the front and rear axles and handlebars are
fastened reliably.
(3)Check the fastening status of handlebar and front and back wheels:
Shake the handlebar up, down , front, back, left and right to check whether it is loose or pongee;
Shake left and right front and back wheels to check whether there is looseness; whether the rotating wheel is
too tight or stuck.
(4)Tire inspection:
Check that the wheel inflation pressure is within the range marked on the tire.
Whether the tire has cracks or abnormal wear;
Whether the tire is embedded with nails, stones and glass;
When the tire is used to the tread wear mark, the tire should be replaced.
(5)Inspection of reflector and license plate:
Check whether the reflector is missing. If it is found missing, contact the after-sales service immediately to
reassemble the reflector of the same specification and model, and the installation position should be consistent
with the original bicycle .Please do not change the position, modify, disassemble, etc. privately.
Before each use, check that the function of the reflector is normal and the surface of the reflector is kept clean.
The Reflector device cannot be blocked by luggage, children chair, clothes and other objects, otherwise it will
cause potential safety hazards.
Check whether the license plate is installed firmly, whether the number is clear, whether there is any damage
or pollution, and if there is any should, reinforce, clean or replace it in time.
Before each ride, please make sure that the following items: whether the frame lock, vertical tube lock, seat
tube locking fastener are locked, whether the brake system is normal, and the tires are full of gas to ensure
riding safety!
All endurance mileage data of the battery in this manual are from tests done in ADO outdoor test site on
the condition that the battery is full, at 25°C, with no wind, and under 65kg load. It is normal that the actual
riding mileage may be significantly different due to rider habits, weight, road conditions, weather, etc.
04
Publicidad
