Publicidad
Idiomas disponibles
Idiomas disponibles
4. OPERATION
Always follow the safety notes and the relevant safety code.
Check that the outside of the battery unit or appliance are clean and dry
before connecting the charger.
Connecting and removing the battery. Fig.A
Place the battery in the machine (1-Fig.A) and drive it home until it is locked in
place (2-Fig.A).
Do not use brute force to insert the battery pack. If it is difficult to insert the
battery pack, it may because it is not being inserted properly.
To remove the battery, press the lock buttons either side (1-Fig.A) of the battery
before removing it.
Safety system
Please make sure that all safety systems are working properly before using the
nail gun, to ensure that the nail gun does not work when only the trigger is
pressed or only the safety lever is depressed by the wood. The nail gun will only
work when both operations are performed at the same time. Ensure that there
are no nails loaded and that the nail ejector is not pointed at yourself or others
before testing the nail gun for any malfunction.
Assembly
Please do not place your finger on the trigger before conducting any assembly
operation on the nail gun, and remove the battery pack.
Be careful when using the nails and cartridge. If handled improperly, it may cause
the nails to deform, due to which the nailing operation may not work properly or
it may cause the nails to jam.
Avoid storing the nails in very humid places with high temperature or under
direct sunlight.
Please do not use nails not specified in this manual or nails that are damaged,
bent, rusted or corroded.
Please do not insert different-sized nails into the cartridge at the same time, as it
may cause the nailing operation to fail or cause the nails to jam.
Never use this staple gun to fasten electrical cables: the staples can da-mage the
insulating material of electrical cables thereby causing an electric shock or risks
of fire.
Filling the magazine. Fig.C
Press the magazine slide catch (1-Fig.C) unhook the magazine slide and pull
y
(2-Fig.C).
Insert staples or nails in the filler (3-Fig.C) Close the magazine slide (4-Fig.C).
y
Operation
Place the nail ejector on the wood to be fastened, and hold the nail gun firmly
against the wood, to depress and switch on the safety lever. The power indicator
on the nail gun will switch on. At this point, pull the trigger to start nailing. If
61
EN
Publicidad
