Publicidad
Motor
Arbre d'entrainemer
du moteur
Eje del motor
Belt
Courroie
Correa
Agitateur
Agitador
Lay unit on floor bottom up with
nozzle flat.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator and the end caps
(see CLEANING AGITATOR, p. 46).
Motor
du moteur
Eje del motor
Courroie
Correa
Agitateur
Agitador
End Cap
Bouchon
Tapa del
extremo
Groove
Rainure
Ranura
Loop new belt (part number
MC-V390B, Type UB12) around
motor shaft and agitator belt
groove.
Make sure belt is routed in
the belt guide as shown.
See
illustration for correct belt routing.
Reinstall agitator back into nozzle
by placing end caps into grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is
not twisted or pinched and that all
rotating parts turn freely.
Place the vacuum in the upright
position standing on the handle.
This will minimize wheel
interference when installing nozzle
bottom plate.
Reinstall nozzle cover by (1)
aligning front edge of the cover with
the nozzle and (2) rotating to
installed position.
- 44 -
Publicidad
