PARTS
1
2
3
4
5
1. Control panel
2. Horizontal louvers
3. Vertical louvers
4. Handle
5. Castors
OPERATION
ASSEMBLINg CASTORS:
Put the appliance on a flat surface, take out the wrench from foam box, then
assemble the castors.
Attention: the back castor is with brake, but the front one is not.
FILLINg THE WATER TANK:
If users want it to do cooling, pour water into the water tank. Firstly, set the water limit
level knob to be horizontal position, and slowly pour water inside.
ATTENTION:
- Pay attention to the water level mark on the water tank before pouring water.
- Place the water tank back to its original place after finishing water pouring.
- Make sure to use clean tap water.
- Includes 2 ice packs.
- Do not put the ice pack into when the water tank is full, the water may overflow.
- Before using, add water to the ICE BOX not more than MAX. Do not put the inside
gel directly into the water tank.
-The ice pack should be frozen before using.
- Keep the ice pack away from children and animals.
CONTROL PANEL:
This air cooler uses multifunctional mechanical buttons. You can select the functions
as follows:
1. Wind speed: there are 4 speed levels: 0-stop, 1-low, 2-middle, 3-strong. The button
EN
6
7
8
11
6. Honeycomb filter
7. Ait filter
8. Water pump
9. Ice pack
10. Water tank
5
13
14
12
9
10
15
11. MIN/MAX water levels
12. Water tank knob
13. Filter knob
14. Filter holder
15. Power cord
11
castor with
castor
brake
CONTROL PANEL
0
1
1
3
2
2
3
1
0
COOL
2
SWING
3