Home Decorators Collection DYLAN 60 Instrucciones De Montaje página 4

WALL-TO-WALL DIMENSIONS
• Measure the thickness of your finished surface on either side before installing the metal tracks.
• Make sure to have a finished surface distance (D) between the min and max permissible dimensions according to the table
below.
*IMPORTANT: Your shower is designed to accommodate a 1 9/16 in tolerance from the maximum value. If needed you
can cut the support bar to fit the shower.
D
FINISHED SURFACE OPENING (D)
SHOWER DOOR HEIGHT
(Make sure the door height is not surpassing your tile /
Support bar adjustability
acrylic wall height)
MIN** MAX*
55 15/16 in 60 1/16 in 76 in
WARNING!
L
**If you require to cut the bar, refer to the calculation below:
1. Measure the distance "D" at the height where the bar will be installed.
2. Cut the bar to a total length of L = D - 7/8 in.
3. The maximum measure to cut from the bar should be no more than 2 9/16 in.
L = D - 7/8 in
PAGE 4