Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, 1/4 x 1-1/2
1
Handle
1 - Handle Grip
2 - Screws, #10-16 x 1
Tools Required
for
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
installing
Handles,
Wheels,
and Molded
Foot
:whee,s
handle
do not provide
adequate
cmearance,
stability
or support
for pulling the
unit up and down stairs or steps,
The unit must be lifted, or pushed
up a ramp,
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
It will be necessary
to brace or
support
one side of the outfit when
installing
the wheems because
the
compressor
will have a tendency
to
tip over.
3.
InstalI one shoulder bolt
and one nut for each wheel.
Tighten securely. The outfit
will sit leve!
if the wheels are
properly installed.
\
WheeR
Nut
/
4.
Shoulder
Bolt
Clean and dry underside of
air tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of leg
on each end.
Press firmly into
place.
A14080
10-ENG
Publicidad
