Airthings RENEW Manual De Instrucciones página 6

GETTING STARTED
Remove Renew and the power cord from the box. Place the unit on the floor
nt options ions
with the control panel facing up.
options
Quick start guide
STEP 1. Connect the power cable to the unit.
Lay Renew gently on its side so you can access the cable storage compartment
on the bottom side. Remove the compartment cover and connect the power
cord. With the location of the power outlet and placement of the unit in
mind, wind up any excess length of cable in the compartment after replacing
the cover.
ble
e
STEP 2. Connect to power
Plug the power cable into a 110V (US) 220-240V (EU/UK) electrical outlet. The
unit enters Auto mode and the air quality sensor begins to sample the air.
STEP 3. Connect to WiFi
nting
ng
Download the Airthings app and follow the instructions to create an account,
connect to your WiFi, and add Renew to your account. If you already have an
Airthings account, tap Add device to add Renew and you're ready to go.
To disconnect from WiFi, go to the device settings in the app, or see instructions
in this manual to "factory reset.
Note: For WiFi connectivity, Renew requires a 2.4 GHz band router and the Airthings app. The Airthings
app requirements can be found in the App Store and Google Play.
EN
10
Ortho views
Placement options
Placement options
Placement options
Power cable
Power cable
Power cable
Wall mounting
Wall mounting
Getting the most out of your Renew
Renew is designed to fit easily into your environment and offers a few
different placement options.
Upright
Laid flat
However you choose to place Renew in your room, we suggest you consider the
following to get the best performance.
• Only place the unit on a level and stable surface.
• Don't place anything on top of Renew.
• Renew takes air in through the textile cover
and blows it out through the vented surface
next to the control panel. Make sure you
leave at least 8" (20cm) of free space so that
air enters and leaves Renew freely.
• Avoid blocking the flow of air into the
particulate sensor. Leave at least 8" (20cm)
around the opening for the sensor.
• Operate Renew in an enclosed space
to get the quickest results and to
operate efficiently.
Upright with air
outlet to the side
EN
11