Airthings RENEW Manual De Instrucciones página 9

MAINTAINING YOUR RENEW
There isn't much to do to keep your Renew running effectively for years. Along
with changing the filters as needed, we recommend keeping the unit clean and
free from excess dust.
Filters
Changing the filters
Renew tells you when to change the filter based on a smart algorithm. This
ensures everyday filter efficiency if the air is more polluted than average. The
Filter change indicator on the control panel will illuminate. You can also check
the remaining filter life in the app at any time.
You can order replacement filters at airthings.com, in the Airthings app, or at
selected authorized resellers.
Once you have the replacement filters on hand, here's what to do:
1. Unplug the device before changing the filters.
2. Remove the textile front cover (outer prefilter) and inner prefilter.
Cleaning
3. Now remove the old filter and replace it with the new one. Remember to
insert the new filter with the pull-tab face-up and out.
Tip: Place the used filter directly into the bag the new filter comes in to prevent
dust and particles from scattering.
4. Reassemble the prefilters and plug the unit back in.
5. Finally, reset the filter change algorithm and turn off the Filter change
indicator light. To do this, press and hold the Silent mode button for
5 seconds.
Do not try to touch the fan blades when changing the filters.
Ortho views
EN
16
Keeping it clean
Before cleaning Renew, it's a good idea to unplug it.
Wipe the outside of the unit with a clean, dry cloth to remove any accumulated
dust and dirt. Never use cleaning liquids to clean Renew - if you must, only use
a lightly damp cloth. Water or moisture should never enter the unit.
The front cover (also a prefilter) should be cleaned using a vacuum at a very
low and gentle speed. Be careful not to push hard on the textile or you risk
damaging it.
The mesh prefilter can be cleaned with water and a small amount of mild dish
soap. If you have a handheld shower attachment, that's the easiest way to do
this. Use a gentle stream of water or submerge the filter and gently move it
back and forth. You must let the mesh prefilter dry completely before putting it
back in. Moisture can increase the risk of mold growing inside the unit.
Filters
Cleaning
Mesh prefilter
Front cover
EN
17