Publicidad
Idiomas disponibles
Idiomas disponibles
To stop charging
1. The device will automatically power off when the car is fully charged, and the
indicator light shows green. Also, you can actively turn off the circuit switch to power
off. Pull out the charging gun from the car charging port and hang it on the holder.
2. When the device has faults, you can press the red 'emergency stop button' at the side and
rotate in the indicated direction to reset.
Stop 1:
Other problems
• Can start charging but no current
There is a battery icon on the upper right of the screen. If it is gray, it indicates that the S2
switch of the vehicle is not closed. The charging device is waiting for the close of S2 switch. If
the switch is not closed for long time, please try to electrify the vehicle without firing.
• Overvoltage and undervoltage
If the screen displays overvoltage or undervoltage in the lower right corner. Please find an
electrician to check the circuit. Use a multimeter to measure the voltage of the device incoming
wire, and then measure the voltage at the incoming wire of the distribution box.
• Leakage alarm
If the screen shows electricity leakage, it may be the vehicle electricity leakage or the screw at
the device inlet wire is not tightened. First check whether the device inlet wire is tightly
connected. If not, please change another car to charge it for a test.
If there is any abnormal situation in use, please refer to "Troubleshooting of General faults" first. If
you still cannot troubleshoot a fault, please cut off the power supply of the charger and contact
our customer service.
EN
2. Or Emergency Stop Switch
Troubleshooting of General Faults
Possible Cause
Trouble
The power supply not
connected properly
The display
screen doesn't
Circuit breaker tripped
light up
The charger damaged
Charging gun not fully
connected
Unable to start
charging
Rotate emergency stop
button
Charging current
Vehicle acceptance
less than rated
capacity limit or vehicle
value
almost fully charged
The warning light
Some trouble
lights up
TAMITO SAS，176 avenue charles de gaulle,
92200 Neuilly-sur-seine, FR，
service@tamito.fr
EN
Solution
Check if the power input line has
power and if the power switch is
closed
The air switch installed at the
front end of the charging station
must have a leakage trip function,
check the front air switch and
close the circuit breaker switch
Please contact customer service
Check if the charging gun is
securely connected to the vehicle
socket, ensure that the charging
gun is plugged into the bottom of
the socket
Rotate the emergency stop switch
in the direction indicated to
restart
The equipment provides power
according to the need of the
vehicle's on-board charger. The
maximum current value accepted
by the vehicle can refer to the
vehicle manual; When the vehicle
battery level is close to full, the
charging current will decrease,
which is a normal condition. If
not, please contact the customer
service
Please contact customer service
Publicidad
