Publicidad
Idiomas disponibles
Idiomas disponibles
Battipav srl
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment,
disconnect the machine from the supply mains.
Loosen both nuts located on the blade cover guard
and remove it.
Remove the blade fixing nut using the 19 mm
spanner and the 5 mm Allen wrench.
CAUTION
THE BLADE FIXING NUT HAS A LEFT-HAND
19
THREAD.
After dismantling the blade, clean the blade flanges
carefully and check them for wear.
Grease any surface with fine oil and install the new
blade. Check for correct direction of rotation as
clearly indicated on the tool.
CONTROL DEVICES
CAUTION
The EXTRA machine is equipped with a control
20
board made up of:
1) START BUTTON (GREEN COLOUR):
Press the button fully to activate machine
starting.
2) REGULAR STOP BUTTON:
Press the button fully to activate machine
stop.
3) DEVICE FOR DISCONNECTION FROM THE
MAINS (PLUG):
Machine power supply point.
During the maintenance phases, take out the
device plug in order to disconnect the machine
from the mains.
4) LASER MARKER
It projects the cutting line on the table.
It is enabled when the machine is connected to
the mains.
CUTTING ON THE TABLE
CAUTION
BEFORE PERFORMING THE CUTTING OPERATIONS,
MAKE SURE THAT THE MATERIAL IS PROPERLY
LEANED AGAINST THE TILE STOPPER.
CAUTION
BEFORE
STARTING
21
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEFT FREE
AROUND THE MACHINE (Pos. 2).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR
THE
MACHINE
OPERATIONS.
THE OPERATOR STANDS IN THE WORKING
POSITION (Pos. 1) DURING THE DIFFERENT
MACHINE OPERATION PHASES.
22
Different types of cutting are possible thanks to
the high versatility of the EXTRA saw.
Position the piece to be cut on the working
table and make sure that is properly leaned
against the tile stopper.
CAUTION
THE MILLIMETRE RULER PLACED ON THE
WORKING
TABLE
CARRYING OUT OF LINEAR CUTTING.
CUTTING A SURFACE AT 45°
CAUTION
Before positioning the motor head, make sure that:
•
the machine is off;
•
the cutting tool is not moving;
Referring to the graded scale located on the
23
machine upright, move the motor head to the
JOLLY position and tighten the knobs.
With the locking lever, lower the cutting head until
placing the blade some millimetres below the table
level.
THE
CUTTING
DURING
THE
CUTTING
HELPS
ONLY
WITH
GB
THE
27
Publicidad
