UFESA Nevada Manual De Instrucciones página 18

follow the instructions described below.
Do not cover or obstruct the product when in use.
This device is designed for use at a maximum alti-
tude up to 2000m above sea level.
IMPORTANT INFORMATION
This appliance is intended exclusively for domestic use for ventilation of rooms: do not
use it for other purposes. Any other usage should be considered improper and dangerous.
The manufacturer shall not be held responsible for any damage resulting from improper,
incorrect and irresponsible use and/ or for repairs made by unqualified technicians.
Do not insert fingers or any other objects through the fan's protector grille. The appliance
must be kept out of the reach of children. Do not use the appliance if it is not working pro-
perly, or if it appears to be damaged; if in doubt, take it to a professional, qualified techni-
cian. Do not move the appliance while it is operating. When the appliance is not being used,
remove the plug from the mains socket. Do not touch the appliance with wet hands or feet.
Do not drag the appliance by the cable to move it. Do not pull the cable or the appliance
itself to remove the plug from the mains socket. To clean the appliance, follow the instruc-
tions in the section of the manual dedicated to cleaning and maintenance.
The water should be replaced every 3-4 days, even if it has not been used. In case the
appliance has not been used for long periods, remove the water from the humidifier.
B&B TRENDS, S.L. will not be held liable for any harm or damage which may occur to peo-
ple, animals or objects as a result of failure to observe the aforementioned warnings.
UTILIZAÇÃO
Before use:
- Make sure all the packaging has been removed from the appliance.
Assembling the mist fan:
ASSEMBLE THE BASE
- Insert the 4 pcs wheels (20) into the weight rubber (19),and tighten up by the screws (21)
and the gasket (22).
ASSEMBLE OF BLADE AND GRILLE (FIG. 1)
- Unscrew the plastic mounting nut from the front of the motor housing by rotating it
anticlockwise.
- Position the rear grille against the front of the motor housing with the handle uppermost,
ensuing that the locating pegs on the motor housing are engaged correctly in the holes of
the rear grille.
- Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
18