HIKOKI DH 3640DA Instrucciones De Manejo página 12

English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
○ If the BSL36B18X is installed in the power tool, the
power output will exceed 100 Wh and the unit will be
classifi ed as Dangerous Goods for freight classifi cation.
Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1–Fig. 23)
1 Drill bit
2 Selector lever
Continuous operation
3
button
4 Switch trigger
5 Handle
6 Nameplate
Rotation speed
7
selector switch
8 Display lamp
9 Battery
10 Tail cover
11 LED light
12 Housing
13 Motor
14 Side handle
15 Grip
16 Front cap
17 Stopper lever
18 Latch
19 Charge indicator lamp
Remaining battery
20
indicator switch
Remaining battery
21
indicator lamp
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
DH3640DA: Cordless Rotary Hammer
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
Bpm Full-load impact rate
12
22 Display panel
23 Grease
24 Band
25 Handle bolt
26 Mount
27 Band attachment area
28 Stopper
29 Wing bolt
30 Core bit shank
31 Core bit
32 Guide plate
33 Center pin
34 Core bit tip
35 Terminal (Product)
Sliding grooves
36
(Product)
37 Air gun
38 Terminal (Battery)
Sliding grooves
39
(Battery)
40 Rubber cover
41 USB port
42 USB cable