Publicidad
Idiomas disponibles
Idiomas disponibles
GB
To remove oven door with soft closing hinges:
36
F
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
1. Open the door completely.
2. Lift the pull-out hooks located on the two
hinges. If you cannot lift them manually, use
a tool as a lever.
3. Completely rotate downwards the pull-out
hooks.
4. Holding the door by its two outer sides,
slowly close it but not completely. Pull the
door to remove it from its seat (see figure). To
re-assemble the door follow the procedure in
reverse order.
5. Rotate the pull-out hooks upwards until they
touch the front of the oven.
6. Push the pull-out hooks downwards, making
sure they are steady and do not rotate
forward.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
Lamp
Holder
compartment
Lamp
Glass cover
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
Automatic cleaning by PYROLYSIS
The cleaning cycle can cause the internal temperature of the oven to reach
500°C. The pyrolytic cycle is activated, burning away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• do not place tea towels or pot holders over the oven handle.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The programme may only be started once the oven door has been closed.
To activate the cleaning cycle
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the control dial, select
PYROLYTIC and press
.
4. The appliance suggests a "NORMAL" pyrolytic cycle, with a duration of 1
hour 30 minutes. Other levels of cleaning may be selected.
• Use the control dial to select one of the following:
"ECONOMY": duration 1 hour
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
:
Publicidad
