TREVIDEA G3 Ferrari PULISCO G90011 Manual De Instrucciones página 13

ASSEMBLING THE ACCESSORIES
- Insert the hose (8) in the suction nozzle (3), pushing it until blocking. The flexible hose terminates in the
handle (10), a curved tube equipped with a hole for adjusting the air flow (11). With this controller you can
reduce or increase the suction power.
- Fit the telescopic tube (12) to the handle (10). The tube can be extended pushing the black button present on
the tube. Attach the floor brush (13) (normal or parquet) or the multi-function nozzle to the extension tube.
The nozzle can be oriented horizontally or vertically depending on the type of the area you need to clean
and it is equipped with a mini-brush. Pull out the power cord to the desired length and plug it to the main
electrical outlet.
OPERATING CONTROLS
- Power on: press the power button (1) and the device is turned on/off.
- Cable rewind: after use, unplug the appliance from the electrical outlet and press the button (2) to rewind
the power cord.
CAUTION: when rewinding the power cord, it is recommended to pick up the plug to avoid whiplash.
REMOVING THE CONTAINER
The dust bin (4) must be emptied when full of dust. In any case empty it frequently, in order to ensure good
performance of the vacuum cleaner and to prevent any leak in the air flow power.
To empty the bin, follow the instructions below:
- Press the dust bin release button (A) WITHOUT PUSHING THE LID (B) DOWN; extract the dust
container from appliance, pulling it up.
- Bring the dust container (4) over a bin and pull the filter (E) to remove it. Eventually clean the filter as for
paragraph "Filter mantainance".
- To open the lid of container (B):
o Press the button (C, Push) that is over the filter (E).
o Pull the lid up.
- Turn the container (4) pside down and lightly beat it to bring down the last remnants.
- Close the lid and mount the filter as for below steps.
o
In the front part of lid (B) there are 2 pins. Make them match with the 2 joints present on the front
side of container (4).
o
Keeping the pins in position, lower down the lid (B) and push it on container until it locks.
o
Take the filter (E) and turn up the plastic tongue present on it.
o
Mount the filter in its seat on the back of container, pushing with the tongue the safety pin that exits
from the lid (if filter is not well mounted and the pin is not pressed, it will not be possible to mount
the container to the housing).
- Insert the container (4) in its seat on the housing of appliance and push it down until it locks.
FILTER MAINTENANCE
DISASSEMBLING THE FILTER SYSTEM
Once extracted the dust container (4), as described in previous chapter and
remove the filter (E) pulling it.
- Clean the filter that is under the lid as described in the next paragraph.
The air-outlet filter is placed in the rear of unit, under the resting hook (6). To remove it, follow the steps:
- Remove the grid by pulling the tab and remove the filter (7) inside.
- Clean the filter as shown in the next section.
- During installation make sure to properly assemble the filter and the grid.
CLEANING FILTERS
The filters can be cleaned in various ways. For a brief cleaning lightly beat them on a trash can.
12