Publicidad
NOTE :
This section is only for reference when using a
Lumectra External RGB LED Light Strip (sold separately).
EXTERNAL LEDS - PROGRAM FUNCTION
1. To enter EXTERNAL LED Program Mode on the controller, hold the EXT LED button on the back of
the controller for 2 seconds. The Program / Connection LED will blink slowly while the controller
is in EXTERNAL LED Program Mode.
2. The LED strip will flash 3 times in GREEN color to indicate you are in EXTERNAL LED program mode
and are ready to change LED colors using the controller. The controller will also continuously
flash GREEN while in EXTERNAL LED program mode.
NOTE: While in EXTERNAL LED program mode, your controls to the console will not function.
This is to allow you to press buttons without causing any movement or actions on the game or
console dashboard. The controller sends commands to the LED strip via the IR sensor on the LED
strip. You must point the controller directly at the sensor (line of sight) to enable the EXTERNAL
commands to register and take effect on the LED strip.
3. COLOR SELECTION
Select one of the A/B/X/Y buttons to choose your color: green, red, blue, or yellow.
A. Next, continue pressing the selected A/B/X/Y button to toggle through 6 shades of that
color.
B. Pressing and holding down any of the A/B/X/Y buttons will cycle through the 6 shades of
that color until the button is released.
4. MODE SELECTION
Press the D-Pad Left to cycle through the LED modes on the strip:
A. SOLID – All lights will be steadily lit with a single color. No speed settings for this mode.
B. BREATHING - LED lights will slowly flash; pressing the VIEW button will change speed.
C. CYCLE - LED lights will cycle through all 24 available LED colors; pressing the VIEW button
will change speed.
D. MUSIC SOLID – LED lights will turn on with each noise or sound played; LED colors will
change with each sound as well.
E. MUSIC CYCLE – LED lights will flash in different colors each time a noise or sound is played.
5. BRIGHTNESS ADJUSTMENT
Press "UP" or "DOWN" on the D-Pad to adjust brightness levels. There are 10 available
brightness settings.
6. SYNC
The External LED strip can be synced to one of the 4 Lumectra LED zones on the controller. Press
the RB button on the controller to cycle through each zone. The zone being synced with the LED
strip will flash, and the LED strip will display that zone's color.
7. EXIT EXTERNAL LED PROGRAM MODE
To exit Program Mode, hold the EXT LED button for 2 seconds. All 4 LED Controller Zones and LED
Strip will flash 3 times to indicate the LED strip is now out of LED Program Mode.
8. LED STRIP ON/OFF
Outside Program Mode, press EXT LED once to turn the LED strip on or off.
Publicidad
