cecotec CONGA ROCKSTAR CYCLONIC X-TREME Manual De Instrucciones página 36

ENGLISH
3. PRODUCT ASSEMBLY
To avoid scratching the floor, remove the plastic protection pieces (L and M) before using the
appliance.
WARNING
Make sure that the rubber gasket is securely in place before using the appliance. An
incorrectly fitted gasket can lead to dust leakage and damage to the engine. In figure 2 you
can observe how it looks when it is correctly positioned.
1. Connect the flexible hose into the inlet duct of the vacuum cleaner by turning it 90º
clockwise until you hear a click. Fig. 3
2. After using the vacuum cleaner, remove the hose by turning it 90° counterclockwise and
pull off the end. Fig. 4
3. Insert the extension tube into the tubular handle and then, insert the other end of the
tube into the floor brush as shown in figure 5.
4. OPERATION
Using the vacuum cleaner
Stretch the cable to the desired length and insert the plug into a power socket. Press the
power switch to turn on the vacuum cleaner. You can adjust the suction power using the air
flow control located on the tubular handle.
Warning: do not unwind the cable beyond the RED mark. Fig. 6
How to use accessories
1. Brush for hard floors. Fig. 7
2. Brush for carpets. Fig. 8
3. Nozzle-shaped accessory for cleaning corners, furniture, curtains, lamps, clothing, etc.
Fig. 9
After use
- Press the power switch to turn off the vacuum cleaner. Then, press the automatic cable
rewind button to rewind the cable slowly.
Warning: if the power cable does not wind up completely, pull it out a little and press the
automatic cable rewind button again. Repeat this step until the cable is completely wound.
- After using the vacuum cleaner, place it as shown in figure 10.
36