DeWalt DXV16P Manual De Instrucciones página 6

To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter
out microscopic particles.
For your convenience and safety, the following warning labels are
on your vacuum.
ON MOTOR HOUSING :
WARNING:
• READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
DO NOT LEAVE APPLIANCE WHEN PLUGGED IN. UNPLUG
BEFORE CLEANING AND SERVICING. USE INDOORS ONLY.DO
NOT USE WITH DAMAGED CORD OR PLUG. KEEP CORD AWAY
FROM HEATED SURFACES. DO NOT USE TO PICK UP
FLAMMABLE, COMBUSTIBLE LIQUIDS SUCH AS GASOLINE, OR
USE IN AREAS WHERE THEY MAY BE PRESENT.DO NOT USE TO
PICK UP ANYTHING THAT IS BURNING OR SMOKING, SUCH AS
CIGARETTES, MATCHES OR HOT ASHES. DO NOT VACUUM
TOXIC, CARCINOGENIC, COMBUSTIBLE OR OTHER HAZARDOUS
MATERIALS SUCH AS ASBESTOS, LEAD, PESTICIDES OR OTHER
HEALTH ENDANGERING MATERIALS.
DOUBLE INSULATION – WHEN SERVICING, USE ONLY IDENTICAL
REPLACEMENT PARTS. FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
1.Pull lid latches in an outward motion, remove power head and
some accessories that may have been shipped in the tank.
2.Attach heavy-duty rubberized casters following the instructions
in this manual.
3.Before replacing power head, refer to this manual to ensure
you have the proper filters installed for your cleaning operation.
4.Replace power head, and apply pressure with thumb to each
latch until it snaps tightly in place. Make sure all lid latches are
clamped securely.
5.Insert the air hose end into inlet of tank.
6.Attach the extension wands to the accessory end of the hose.
Apply slight pressure until fitting is tight.
7.Attach one of the cleaning accessories (depending on your
cleaning requirements) on the extension wands. Twist slightly
to tighten the connection.
8.Plug the cord into the wall outlet. Your cleaniner is ready for use.
CASTER ASSEMBLY
1.Invert dust tank, take the caster and the large wheel assembly
to align tank bottom sinking place. Secure with screws provided.
2.Return dust tank assembly upright.
6