Publicidad
Idiomas disponibles
Idiomas disponibles
DRY PICK-UP
1. The filter must always be in correct position to reduce the risk
of leaks and possible damage to vac. Make sure that the filter
is completely covering the filter cage. Make sure there are no
gaps between the filter and the lid. (See illustration). It is very
important to assemble the filter to the cage without allowing
any possible leaks or tears. Any leaks will allow the picked up
debris to be blown out of the blowing port and back into the
surrounding environment.
2. When using your vac to pick up very fine dust, it will be
necessary to empty the dust tank and clean or replace the filter
at more frequent intervals to maintain peak vac performance.
NOTE
A dry filter is necessary to pick up dry material. If you use your
vac to pick up dust when the filter is wet, the filter will clog quickly
and be very difficult to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
The cartridge filter can be used for wet or dry pick, installation is
the same for both.
1. With the power head in an upside down position, slide the
cartridge filter down over the lid cage, push the filter seals
against the power head.
2. Turn the knob on filter retainer clockwise to tighten, locking
the filter into place.
3. To remove the filter for cleaning, turn the filter knob counter
clockwise till feel the tactile and auditory cue, and make sure the
knob arrow align with the "Unlock" icon on the filter cap, then slide
the cartridge filter off the lid cage.
4. To clean the cartridge filter, shake or brush off excess dirt or
rinse (from the inside of the filter) with water, dry completely
(approximately 24 hours) and re-install.
NOTE
If the filter has been used for wet pick-up, it must be cleaned and
dried before using for dry pick-up.
INSTALLING THE DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto the vacuum port
deflector until it stops against the deflector wall.
2. Position the bag so that it is distributed around the inside of the
tank.
3. Replace and secure the power head onto the tank.
Disposable
filter bag
8
Lock
Publicidad
