Scheppach OSM600 Traduccion Del Manual De Instrucciones Originale página 31

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during sanding.
Strong vibrations
Possible cause
ON/OFF switch damaged.
ON/OFF cable damaged
ON/OFF relay damaged
Fuse blown
Motor burnt
Too much pressure put on the
workpiece.
Belt does not run straight.
Sanding disc or belt covered with
grease.
Excessive pressure on work-
piece.
Loosely mounted tool
Defective tool
Spindle knocks
www.scheppach.com
Help
Replace all damaged parts before you use
your machine again.
Contact your local service centre. Every
attempt to carry out a repair, can be dan-
gerous if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
Replace disc or belt.
Reduce pressure on workpiece.
Tighten tool
Change tool
Repair at a Service-Station
GB | 31