Section 4: Opecation
Start engine
according
to instructions
given in engine
owner's
manuaH.AHso
see
operating
instructions
tag
Hocated
on the
pressure
washer.
WARNING
When
starting
engine,
pull cord slowly
until resistance
is felt
and then
pull rapidly to avoid kickback.
Hfengine starts and fails to continue
to run or if increased
resistance
is felt during
starting
pull attempts,
squeeze
trigger
on spray gun.
NOTE;
Always
keep the throttle
lever in the "Fast"
)osition
when
operating
the pressure
washer.
WARNING
DO NOT touch hot surfaces,
Allow equipment
to coot before touching.
The pressure washer must be at least 5 feet from structures
having combustible
walls and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on all sides of pressure
washer
for adequate
coding,
maintenance
and servicing.
Hnthe State of California
a spark
arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other
states
may have similar laws. Federal
laws apply on federal
lands. [f you equip the muffler
with a spark arrester; it must be
maintained
in effective working
order:
How to Stop Your Pressure
Washer
H.
Let engine
idHe for two
minutes.
2.
Turn
engine off according
to instructions
given
in
engine
owner's manual
3.
Squeeze
trigger
on spray
gun
to relieve
trapped
pressure
in hose
to
avoid
iniury.
NOTE:
A smaHH amount
of water
wiHHsquirt
out when
pressure
is reHeased.
1
WARNING
Keep high pressure hose connected
to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to rdieve
trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
4.
Engage trigger Hock on spray gun when not in use.
The unit is equipped with an accessory tray with pHacesto
store your rotating brush, utility brush, turbo nozzHe,and
ProjectPro TM nozzHes.There is aHsoa hook at the front of
the accessory tray to hoHd your high pressure hose.
H. Store your gun and nozzHe extension on the hooks
attached to the base and handHe,as shown in Figure H 2.
2.
PHacerotating brush through hoHe on accessory tray on
right side of unit (Figure H 2).
3.
PHaceutility brush through
hoHe on accessory tray, as
shown in Figure H2.
3.
Push turbo nozzHe up and into chip on accessory tray
untiH it snaps in, as shown in Figure H 2.
4.
Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown in Figure H 2.