Troy-Bilt 020240 Manual Del Propietário página 6

ASSEMBLY
mMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
I. Remove the parts
bag, accessories,
and inserts included
with pressure washer.
2. Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3. Remove pressure washer from carton.
Carton Contents
totems in the carton include:
Hain Unit
Handle
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting
Plastic Accessory Tray
Safety Goggles
Oil Bottle
Turbo Nozzle with Quick Connect
Rotating Brush
Utility
Brush
Parts Bag (which includes the following):
Owner's Manual
Engine Planual
Owner's Registration Card
Bag containing 4 multi-colored ProjectPro TM
Nozzles
Handle/Tray Fastening Hardware Kit (which
includes):
Carriage Bolts (2)
"U' Bolt
Plastic Knobs (3)
Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at m =888=6 mm =6708. If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit, then attach accessory tray
to handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
S. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Selecdattach quick connect ProjectPro TM nozzle to
nozzle extension,
Attach Handle
and
Accessory Tray
I. Place handle onto handle supports connected to main
unit. Make sure holes in handle align with holes on
handle supports (Figure I).
NOTE:
It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports,
O