Publicidad
Idiomas disponibles
Idiomas disponibles
Check
High Pressure
Hose
High pressure hoses can develop leaks from wear,
kinking, or abuse. Inspect hose before each use.
Check for cuts, leaks, abrasions, bulging of cover, or
damage or movement of couplings. If any of these
condkions exist, replace hose immediately.
_, WARNING
The high pressure stream of water
_
hat this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
o NEVER repair high pressure hose. Replace it.
Replacement hose rating MUST equal or exceed
maximum pressure rating of unit.
Check
Detergent
Siphoning
Tube
Examine the filter on detergent tube (if equipped) and
clean if clogged. The tube should fit tightly on the
barbed fitting. Examine the tube for beaks or tears.
Replace the fiffer or tube if either is damaged.
Detergent
Siphoning
Check
Ball
Occasionally check bah in detergent siphoning
system may become stuck from storage, dried soap,
or minerals in water. The check ball can be freed by
performing the following:
NOTICE
Before performing this procedure, be sure
,ou are wearing safety goggles as described below.
A. WARNmNG
Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
or in vicinity of this equipment.
NEVER substitute safety glasses or dry-condition
goggtes for indirect vented safety goggtes.
.
Shut off engine and turn off water suppJy.
ALWAYS point spray gun in a safe direction,
press red button and squeeze spray gun trigger to
release retained high water pressure.
WARNING
The high pressure stream of water
:_
that this equipment produces could cut
through skin and its underlying tissues,
resuffing in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which
could result in serious injury.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
.
4.
Remove detergent siphoning hose from barbed
fitting on pump.
Using a firm, Munt object 7/64" in diameter or
smaller, by at least 1" long, such as an Allen
wrench, slowly insert the object into the barbed
fitting until you meet resistance. This resistance is
the check ball
5.
Slowly push down until you feel the ball move
slightly, push no more than 1/8". Slight pressure
may be required to free the ball.
6.
Repeat steps 4 and 5 if necessary.
7.
Reinstall detergent siphoning hose onto barb
fitting.
8.
Treat with PumpSaver as described in Protecting
the Pump during storage to prevent reoccurrence.
Check
Spray
Gun
Examine hose connection to spray gun and make sure
it is secure. Test trigger by pressing it and making sure
it springs back into place when you release it. Do not
depress red button and test trigger. You should not be
able to press trigger. Replace spray gun immediately if it
fails any of these tests.
18
Publicidad
