Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts. You could also contact us at partsplus@lowes.com.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Adjustable wrench, pliers, and safety glasses.
Installation may vary depending on how the previous showerhead was installed. Supplies necessary
for the installation of the dual showerhead are not all included; however, they are available wherever
plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on the old shower to re-
lease built-up pressure. When installing the new dual showerhead, hand tighten the connections. DO
NOT OVERTIGHTEN. Connections that are too tight will reduce the integrity of the system.
PRODUCT SPECIFICATIONS
Maximum flow rate: 1.8 GPM (6.81 LPM) at 80 PSI
cUPC, WaterSense
Chrome, brushed nickel, oil-rubbed bronze, and matte black finishes
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the main water supply. Remove the
existing showerhead (1.1) using pliers or an adjustable wrench,
if needed. Clean the threads on the shower arm (1.2).
2.
Apply thread seal tape (E) onto the threads of the shower arm
(2.1) in a clockwise direction.
1
1.1
2
3
B
1.2
2.1
E
Publicidad
