Publicidad
Idiomas disponibles
Idiomas disponibles
return springs may be improperly mounted. Certain cleaning agents such as gasoline, carbon tetrachlo-
ride, ammonia, etc. may damage plastic parts.
• Hold power tool by insulated gripping surfaces, when performing an operating where the cu ing
accessory may contact hidden wiring or its own cost. Cu ing accessory contacting a "live" wire make
exposed metal parts of the power tool ("live") and could give the operator and electric shock.
Dear customer:
Should you have any questions, vagueness or second thoughts about our products, we recommend you
to contact our experts in Sales and second thoughts about our products.
We recommended you to contact our experts in sales and Service Department. We recommends our to
our experts in Sales and Service Department, who will advise you and help you find the right answers
to the set questions. Please contact our local distributors or dealers directly.
SAFETY RULES FOR DRILLS
• Hold tool by insulated gripping surfaces when performing an operation where the cu ing tools may
contact hidden wiring or its own cord. Contact with a ("live") wire will make exposed metal parts of the
tool ("live") and shock the operator. Do not drill, fasten or break into existing walls or other blind areas
where electrical wiring may exist. If this situation is unavoidable, disconnect all fuses or circuit breakers
feeding this work site.
• Always wear safety goggles or eye protection when using this tool. Use a dust mask or respirator for
applications which generate dust. Hold it in your hand or across legs. Unstable support can cause the
drill bit to bind causing loss of control and injury.
• Never leave the trigger locked "ON". Before plugging the tool in, check that the trigger lock is "OFF".
Accidental start-ups could cause injury. Position the cord clear of rotating bit. Do not wrap the cord
around your arm or wrist. If you lose control and have the cord wrapped around your arm or wrist it
may entrap you and cause injury.
• Position yourself to avoid being caught between the tool or side handle and walls or posts. Should the
bit become bound or jammed in the work, the reaction torque of the tool could crush your hand or leg.
• If the bit becomes bound in the work piece, release the trigger immediately, reverse the direction of
rotation and slowly squeeze the trigger to back out the bit. Be ready for a strong reaction torque. The
drill body will tend to twist in the opposite direction as the drill bit is rotating.
• Do not grasp the tool or place your hand too close to the spinning chuk or drill bit. Your hand may be
lacerated.
• Do not use the switch "Lock-ON" feature in situation where drill bit binding is likely. (For example: just
before the bit is ready to break through the material, anytime when using a "Hole Saw", auger bits......
etc.) When the bit binds, the drill's body will twist or kickback in opposite direction and the release of
the trigger "Lock-ON" may be di cult.
• Be aware of the location and se ing of the switch "Lock-ON" bu on. If the switch is locked "ON"
during the use, be ready for emergency situations to switch it "OFF", by first pulling the trigger then
immediately releasing it without pressing the "Lock-ON"bu on.
• When installing a drill bit, insert the shank of the bit well within the jaws of the chuck. If the bit is not
inserted deep enough, the grip of the jaws over the bit is reduced and the loss of control is increased.
• Do not use dull or damaged bits and accessories. Dull or damaged bits have a greater tendency to
bind in the work piece.
• When removing the bit from the tool avoid contact with skin and use proper protective gloves when
grasping the bit or accessory. Accessories may be hot a er prolonged use.
• Check to see that keys and adjusting wrenches are removed from the drill before switching the tool
"ON". Keys or wrenches can fly away at high velocity striking you or a bystander.
• Do not run the drill while carrying it at your side. A spinning drill bit could become entangled with
clothing and injury may result.
7
Publicidad
