Publicidad
Idiomas disponibles
Idiomas disponibles
• This tool may be used with sanding and polishing disks, grinding wheels, wire wheel and wire cup
brushes. These accessories must be rated for at least the speed recommended on the tool warning
label. Wheels and other accessories running over rated speed can fly apart and cause injury.
• Avoid bouncing and snagging the wheels, discs or brushes especially when working corners, sharp
edges, etc. This can cause loss of control and kickback.
• Some dust created by power sanding, sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are:
- Lead from lead-based paints.
- Crystalline silica from bricks and cement and other masonry products.
- Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how o en you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved
safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
3. OPERATION
WARNING!
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second
is su cient to inflict severe injury.
WARNING!
Always wear safety goggles or safety glasses with side shields when operating tools.
Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
• Drilling in wood
• Drilling in ceramics, plastics, fiberglass, and laminates
• Drilling in metals
SWITCH OPERATION
To turn the drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.
VARIABLE SPEED
The rotational speed of the drill can be controlled by varying the amount that the trigger switch is
pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger switch is
pulled more.
Pulling the trigger and pushing the stopper keeps it in the switched-on condition which is convenient
for continuous running. When switching o , the stopper can be disconnected by pulling trigger again.
DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE)
The direction of bit rotation is reversible and is controlled by a selector located above the switch trigger.
With the drill held in normal operating position, the direction of rotation selector should be positioned
to the le of the switch trigger for forward drilling. The drilling direction is reversed when the selector is
to the right of the switch trigger.
CAUTION:
To prevent gear damage, always allow the chuck to come to a complete stop before changing the
direction of rotation.
8
Publicidad
