GE GXCF03E Manual Del Propietário página 4

Usingthe water dispenser.
0
Features and Parts List
0 Bottle Support Collar
(WS28X10046)
0 Separator (WS28X10020)
Cold Water Tank
Cold (Blue) Faucet
Rome Temperature (White) Faucet
Dispenser Drip Tray (WS28X10021) and
Grille (WS28X10022)
Base
(Top Cover- WS30X10006)
(Back Side - WS30X10007)
(Bottom Cover- WS30X10008)
(Front Side- WS30X10009)
Seethe back page of thismanual
fororderinginstructions.
@
0
0
Assembling the Base
1. ,\lign tile ti'ollt and back pieces of the
base (pieces labeled 1 and 2), with "UP"
pointing up, and snap togethe:: If it does
notgo together, make sure "UP" is in the
same direction on both pie(es.
2. Place the top cover (piece 3) on top of
pieces 1 and 2 (li'ont and back). Press
down firmly until it snaps into place.
3. Turn the assemlfly ()_r_'l_ a nd place tile
bottom cover (pie(e 4) on top of pieces
1 and 2 (li'ont and back). Press down
firmly until it snaps into place.
4. Turn base over and place the dispenser
on top of tile base.
NOTE:The top (3) and bottom (4)
pieces can be found in the top and
bottom of the carton packaging foam.
Loading the Dispenser
Sanitize the dispenser water tank prior to
installing a full bottle of water for the first time
(see "Cleaning and Sanitizing the Water Tank").
IMPORTANT: Make sure the dispenser is
unplugged. Before placing the water bottle on
the dispenser, wash hands and wipe the top of
the bottle with a clean cloth, Avoid touching the
part of the bottle that will be in contact with the
water dispenser.
Make sure the water level in the top of the
dispenser is low enough to allow for proper
bottle installation, Failure to do so may cause
the dispenser to overflow.
1. Peel the label ti'om tile top cover of the
bottle (ifpresem). Do notremove the
entire bottle cap.
2. Place the bottle on top of tile dispenser
as shown, aligning the dispensing vah_'
probe to the center of the water bottle
cap. Press down until the probe
penetrates the bottle cap, allotting the
bottle to :x'st on the support calla::
3. IMPORTANT: Press both dispense levers
until water runs from both taps.
4. Plug in thu dispenser.
5. Allow 30 minutes liar water to reach cold
telllperat tires,
Contact a local water bottle distributor to
purchase water bottles,