Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Mark the connections on the bath rim (150 mm)
and drill.
3. Mount the pillar unions with the flanges and the
o-rings onto the rim and fix them with the
washers and the nut.
4. Fit on the back-plate to the pillar unions.
5. Fasten the mixer using ball nuts.
6. Fit on the spout body and tighten the allen
screw.
7. Add the escutcheon and tighten using the nut.
8. Fit on flange.
9. Mount the lever head, tighten the allen screw
and fit on stopper.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by pulling the lever head.
Swivel to the left = hot water, swivel to the right =
cold water.
The hose connecting piece turns 360°.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature: 65° C
Centre distance:
Connections ½":
Rate of flow by 3 bars:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
To adjust the hot water limiter on single lever mixers,
please see page 12.
No adjustment is necessary when using a
continuous flow water heater.
6
English
Spare parts
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 diverter
11 o - ring
12 aerator
13 pillar union
14 spout cpl.
15 noise reduction
XXX = Colors
000 chrome plated
090 chrome/gold plated
880 satin chrome
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
150 mm
cold right
hot left
approx. 22 l/min
lever head
flange
escutcheon
nut
cartridge cpl.
service set
seals
mixer ball
pull knob
aerator gold plated
15491XXX
94063XXX
94261XXX
94200XXX
94106000
14096000
13952000
13962000
13964000
13471XXX
13470000
94485000
13485000
94981990
92470XXX
92410XXX
94073000
6
Publicidad
