Publicidad
Idiomas disponibles
Idiomas disponibles
10.5.2
Wine shelves
Usual shelf
Storage depends on the bottle size and kind.
10.5.3
To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out,
(eventually untighten the screws).
Please note
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the wine shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
10.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
This unit is not designed to be installed in an RV or used with an inverter.
The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Lower shelf
30
Publicidad
