Freezer
Compartment
Lamp
Dispenser
Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage
Bin
After Dispenser
Is Used
How to Dismantle
Parts
Separatethe lamp by pulling it out ® while
slightlystrikingd) and rotating ® the lamp cover.
Turnthe bulb counterclockwise.Max.40 W bulb
for refrigerator is used and can be purchased at
a service center.
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, lift the left part of the shelf
a bit, push it to the direction @,lift the right part
to the direction ®, and take it out.
Lift the door rack holding both sides (b and
pull it out to ® direction.
Lift the ice shelf as shown in the right figure
@ and pull it out ®.
Hold the ice storage bin as shown in the right
figure and pull it out ® while slightly lifting it
®.
• It is recommended not to dismantle the ice
storage bin unless it is necessary.
• Use both hands to remove the ice bin to avoid
dropping it.
• If the ice bin does not slide into place easily,
twist the drive device slightly.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.