Publicidad
Idiomas disponibles
Idiomas disponibles
Pass the
Pass the refrigerator laterallythrough the access
refrigerator
door as shown in the right figure.
Before
installation
Warning
Disposal
of the
old appliance
Mount
the freezer
and refrigerator
compartment
doors
Mount them in the reverse sequence of removal after they pass through the access
door.
Water supply installation
• Automatic icemaker operation needs water pressure of 21 N121 psi (1.5N8.5
kgf/cm2)(That is, an instant paper cup (6 oz. or 180 cc) will be fully filled within
3 seconds.)
• If water pressure does not reach the rating 21 psi (1.5 kgf/cm 2)or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
• Keep the total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is 26' (8 m) or longer it may cause trouble in
water feed owing to the drain water pressure.
• Install the water supply line where it will not be affected by heat.
• Connect to potable water supply only.
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
agency.
Publicidad
