GE 21 Manual Del Propietario Y Instalación página 18

Installation Instructions
INSTALLING THE ANTI-TIP FLOOR
A WARNING
Under certain circumstances, this refrigerator
can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this
refrigerator.
ITI MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for ang countertop
overhang, baseboard thickness and ang
clearance desired. Width, W, should not be less
than 36 inches. The refrigerator will be placed
oppro×imotelg in the middle of this opening.
RearWall
W
14
I
i
,_
REFRIGERATOR
Front
Baseboard
Thickness
or Countertop
_,- _ Overhang
,_i (Whichever
Is Greater)Plus
Any Desired
Clearance
RHSide
BRACKETIonzl ft.
models)
LOCATING THE ANTI-TIP
FLOOR BRACKET
Place the anti-tip floor bracket Iocotor template
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W, and in line
with the desired location of the RH side of the
refrigerator (see Figure 1).
Figure1 - Installation Overview
2 Wall Holes
Floor- Concrete
on the ...... _ RHSide of
Refrigerator _ Refrigerator
LocatorTemplate
Sheet
r_ Place the anti-tip floor bracket onto the Iocutor
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
approximatelg 7½ from the edge of the sheet
or the RH side of the refrigerator.
r_ Hold down in position and use the anti-tip floor
bracket us u template for marking the holes
bused upon gout configuration and tgpe of
construction us shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
• It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of
the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable mounting configurations
for screws. Identifg the screw holes on the
anti-tip floor bracket for gout configuration.
18