Publicidad
Idiomas disponibles
Idiomas disponibles
INSTASTART™
Electronic Ignition
n Turn fuel valve on. Push the red igniter button
and a spark should jump between the electrode
and air tube and ignite the mantles.
NOTE: If lantern does not light after pushing the
igniter button a few times, repeat above step after
turning fuel valve completely off. If the lantern is
wet due to rain, high humidity, etc., the valve may
not spark. Use match lighting procedure
as follows.
Match Lighting
n Push lighted match through lighting hole, hold
near mantle and open fuel valve fully.
WARNING
• BURN HAZARD
• Never leave lantern unattended when hot
or in use.
• Keep out of reach of children.
n Brightness may be adjusted with fuel valve.
n The lantern may be carried by the handle.
To Turn Off
n Turn fuel valve off.
To Store
n Make sure lan-
tern is cool.
n Move lantern
away from flame
(including pilot
lights) and other
ignition sources.
n Disconnect
propane cylinder
from lantern.
n Replace
protective cap on
propane cylinder.
n Collapse the legs
by first grasping
each leg near the
bottom of the
lantern frame. Then
gently pull each
leg away from the
lantern and rotate
until the leg clicks
into its collapsed
position. Repeat for
all 3 legs. Lantern
may be stored in
included carry case.
English-5
Publicidad
