AL-KO HT 4055 Traducción Del Manual Original De Instrucciones página 25

Help in case of malfunction
ter and/or aggressive cleaning agents or sol-
vents - risk of corrosion and damage to the
plastic parts.
■
After every use, remove the rechargeable
battery and inspect the appliance for dam-
age.
■
Clean the cutting blade and spray with corro-
sion protection oil.
■
Regularly check the cutting blade. Contact
one of the manufacturer's service centres in
the event of:
■
Defective cutting blade
■
Blunt cutting blade
■
Excessive wear
■
Inspect all bolts for tightness.
Malfunction
Engine does not start.
Motor keeps cutting out.
Cutting blade gets hot.
Smoke development.
Branches are not cut off
cleanly. Branches often
jam in the cutting blade.
Motor running, but the cut-
ting blade does not move.
Appliance vibrates unusu-
ally.
442355_d
Cause
Battery is flat.
Battery missing or not insert-
ed correctly.
Power supply is interrupted.
The motor protection switch
has switched off the motor
due to overload.
■
Appliance fault
■
The ON/OFF switch is
defective.
No oil on the cutting blade.
■
Cutting blade is blunt.
■
Nicks in the cutting
blade.
Cutting blade is blunt.
Sliding play of the cutting
blade is too large.
Appliance fault
Appliance fault
■
Inspect the electrical contacts of the appli-
ance for corrosion, clean with a fine wire
brush if necessary and then spray with a con-
tact spray.
8 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Charge the battery.
Install the battery correctly.
1. Remove the battery.
2. Clean the plug contacts of the ap-
pliance.
Wait until the motor protection switch
enables the motor again.
Contact one of the manufacturer's ser-
vice centres.
1. Switch off the appliance and re-
move the battery.
2. Clean and oil the cutting blade.
3. Install the battery again.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
25