ENGLISH
Warning:
-
To prevent the soleplate from leaking, do not keep the steam burst button pressed for
more than 5 seconds.
-
For optimal steam burst, do not press the steam burst button more than three times in a
row to prevent the iron from cooling.
Spraying
The spray function can be used with any temperature setting during the steam ironing or dry
ironing mode, as long as the tank is full.
Touch sensor
The iron includes a touch sensor in its handle. For safety reasons, the iron will only emit
continuous steam when held by the handle in a horizontal position.
Pressure-generating pump
Fig. 2
1.
The iron features a pressure pump that generates maximum steam and removes the
harshest creases.
2.
To activate it, press the i-PUMP button once. This button is located at the top. During
operation, the LED light will remain on, and a slight sound will be heard.
3.
To deactivate it, press the button again and wait until the light turns off.
Self-cleaning
1.
Make sure the appliance is unplugged.
2.
Fill the water tank up to the maximum mark and close it (do not put vinegar or other
treatment agents in the water tank.)
3.
Select the maximum temperature mode.
4.
Plug the device into a power supply.
5.
Unplug the appliance when it reaches the temperature.
6.
Hold the iron horizontally, turn the steam knob to the maximum position, press the self-
cleaning button and shake the iron gently from one side to the other. Place a container or
bowl beneath the iron.
7.
The soleplate will emit boiling water and steam to remove all impurities.
8.
Release the self-cleaning button once the water tank is empty.
9.
Repeat this process if necessary.
After the self-cleaning process, plug the iron to a power socket and let it heat so the soleplate
dries, unplug the iron when it has reached the established ironing temperature, move the
hot iron softly over a piece of fabric to remove water stains which may have formed in the
soleplate, then let the iron cool down before storing it.
42
IRONHERO 3200 I-PUMP