ge.com
Cool Mode
Use file Coolmode at Low, Med, High or Auto Fan
Speed for cooling. Use tlle Temperature Increase • /
Decrease• pads to
set
the desired
temperature
between 64°F and 86°F in 1°F increments.
kal electronic
dlemlostat
is used to maintain
die
room temperature.
Tile compressor
will cycle on
and off m keep the room at the set level of comfort.
Set the tbemlostat
at a lower number
and the indoor
air will become
coolex. Set the tbemK_stat
at a higher
number
and the indoor
air will become
waIIneL
CoolingDescriptions
ForNormalCooling--Selectthe Coolmode and
High or Med fan with a middle set temperature.
ForMaximumCooling--Selectthe Coolmode
and Highfan with a lower set temperature.
ForQuieter& NighttimeCooling--Selecttile
Cool mode and Low fan with a middle set
temperature.
NOTE: ff theair conditioner i s off andis thenturnedon
whileset toa Coolsettingor if turnedfroma fansetting
toa Coolsetting,it maytakeapproximately 3 minutes
forthecompressor to startandcoolingto begin.
Energy Saver Mode
Controls
tile fan.
0N--The
fan will cycle on and offwith
tile
compressoL
This results in wider vaIiafions
of room
mmpetamre
and humidil),.
NormaUy
used when
tile
room is unoccupied.
NOTE: Thefan may continue to run
for a short time after the compressorcgcles off.
OFF--TIle
fan runs all tile time, while die
compressor
cycles on and off:
Fan Only Mode
Use the FanOnlyMode at Low,Medor Highfan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a Set temperature
cannot be
enmred. Tile room mmpemmre
will appear
in tile display.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Auto Fan Speed
Set to Auto fan speed
for die fan speed
to
aummaficMly
set to die speed
needed
m provide
optimum
comfort
settings with tile set mmperaUlre.
If file room needs more cooling, file fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decre_tse.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Air Direction
Use die levers m adjust die air direction left and
right.
Fingertip pressure on die louver banks adjusts tile
air direction up or down.
Remote Control
To ensure
proper
operation,
mm tile remora
cormel
at tile signal receNer
on tile air
condifione_.
Tile remora control sigmMhas a range of
up m 20 feet.
Make sure nodling is between die air conditioner
and tile remote conUol that could block the
signal.
Make sure batteries are flesh and installed
correcdy as indicamd on tile remora conuol.
5