4. PREPARE THE HOOD (CONT'D)
Punch out the appropriate electrical knock-out hole.
Using a long nose pliers, remove the knock-out for the chosen opening (vertical on top or horizontal at the back of the hood).
See figures below.
VERTICAL DISCHARGE
HORIZONTAL
DISCHARGE
HDO153
5. INSTALL THE ADAPTER/DAMPER
NOTE: If this hood replaces another one, please note that the location of the air exhaust can vary from one manufacturer to another.
HORIZONTAL DISCHARGE, NEW INSTALLATION
HORIZONTAL DISCHARGE, HOOD REPLACEMENT
Fold
down
the
foldable
flange
(C)
of
the
It may be necessary to adjust the adapter/damper location
adapter/damper. This flange must be at 90° from the
to the existing wall discharge opening. Leave the foldable
remaining flanges. Use the lower screw holes on
flange
(C) of the adapter/damper
as is. Use the upper
each side of the adapter/damper to assemble it to the
screw
holes
on
each
side
of the
adapter/damper
to
back of hood. See below.
assemble it to the back of hood. See below.
HJ0006