Publicidad
Idiomas disponibles
Idiomas disponibles
Wiring Requirements
WARNING: Safety measures should be taken before
connecting the power cable. Turn off the power before
connecting modules or wires. The correct power supply
voltage is listed on the product label. Check the voltage
of your power source to make sure you are using the
correct voltage. DO NOT use a voltage greater than
what is specified on the product label. Calculate the
maximum possible current in each power wire and
common wire. Confirm all electrical codes dictating the
maximum current allowable for each wire size. If current
exceeds the maximum rating, the wiring can overheat
causing serious damage to your equipment.
Please read and follow these guidelines:
• Use separate paths to route wiring for power and devices. If
power wiring and device wiring paths must cross, make sure the
wires are perpendicular at the intersection point.
Note: Do not run signal or communications wiring and power wiring
through the same wire conduit. To avoid interference, wires with
different signal characteristics should be routed separately.
• You can use the type of signal transmitted through a
wire to determine which wires should be kept separate.
Wiring that shares similar electrical characteristics can be
bundled together.
• You should separate input wiring from output wiring.
• Be advised that you should label the wiring to all devices
in the system.
7
Publicidad
